Costing of Multipanels

Multi panels where all boards are < 16 inches²
The minimum area of PCBs which can be ordered is 16(2) inches.
Where there are boards which are smaller than 16 inches²,
we will automatically produce as many as fit in this area. If a route charge (10 usd) is paid we can deliver these as single units. If the boards should be delivered as one piece then only outline should be supplied. As an alternative you can instruct us to deliver a panel with the boards held on pips. ( Extra charge ) The rout and soldermask charge will only be applied once in this case.

Combined multi-panels with PCBs < 16 inches² and PCBs > 16 inches²If your multi-panel is mixed with PCBs both larger and smaller than 16 inches² they will be split up and produced and invoiced separately. The PCBs which are > 16 inches² will be charged individually and a solder mask and milling charge (where applicable) will apply in each case. The PCBs which are < 16 inches² will be combined and one solder mask charge and one milling charge will apply.

Panels with PCBs held on lands ≤ 0,79 inch x 0,79 inch For quality assurance reasons PCBs ≤ 0,79 inch x 0,79 inch are produced and delivered on panels (PCB holders).

There are no additional costs (land milling fee).